Agilent Technologies 4395A - Connecting an Impedance Test Kit and a Test Fixture for Impedance Analyzer Mode

Connecting
an
A
ctive Probe
Connecting
an
Impedance
T
est
Kit
and
a
T
est
Fixture for
Impedance
Analyzer Mode
Connecting an
Impedance T
est Kit
To
start the
impedance measurement,
you need
to connect
the
43961A
Impedance
T
est
Kit
to
the 4395A
. See
Figure 2-9
.
1. V
erify the
4395A is
turned o.
2. Connect
the N-cable
to the
RF OUT
port
of
the
4395A
.
3. Connect
two connectors
of
the
43961A
to
the
R
and
A
ports
of
the
43961A.
4. Connect
the other
connector
of
the
N-cable
to
the
RF
IN
port
of
the
43961A.
5. Turn
on the
4395A
.
Figure
2-9.
Connecting
the
Impedance
T
est
Kit
Connecting a
T
est
Fixture
to
the
Impedance
T
est
Kit
To connect the test xture to the impedance test kit, see the applicable test xture manual for
instructions
. The following is a general procedure:
1. Turn the APC-7 connector of the impedance test kit OUTPUT
port.
2. V
erify that the connector sleeve is retracted fully
.
3. Set the mounting posts of the test station into the twin locating
holes at the corner of the
test xture
.
4. Connect the connector on the underside of the test xture to the OUTPUT port of the
impedance test kit.
2-16 Installation Guide