Agilent Technologies 54624A Service Guide

6-14
Replacing Assemblies
To remove the power supply
6
Using the T20 TORX driver, remove the screw holding the power supply
board to the deck.
Figure 6-11
Removing the power supply
7 Slide the power supply board toward the front panel about 1/2 inch. Slip
the power supply board keyhole slots off of the pins on the deck.
service.book Page 14 Wednesday, December 18, 2002 8:35 AM

Agilent Technologies 54624A Specifications

General

Brand	Agilent Technologies
Model	54624A
Category	Test Equipment
Language	English