General Information 11
1
General Information
Introduction
Two guides are shipped with your power supply - an Operating Guide (this document) and a Programming Guide. You will
find information on the following tasks in these guides:
Quick Document Orientation
1
Topic Location
Calibrating the power supply Appendix A - this guide
Compatibility programming language Appendix B - Programming Guide
Configuring the digital port Appendix D - this guide
Line voltage:
Connecting ac power source Chapter 2 - this guide
Converting the ac source voltage Appendix B - this guide
Source current, frequency, and power ratings Chapter 1- this guide
Operator replaceable parts Chapter 1- this guide
Operator troubleshooting Chapter 3 - this guide
Output impedance characteristics Chapter 1- this guide
Power supply accessories Chapter 1- this guide
Power supply operating characteristics Chapter 1- this guide
Power supply options Chapter 1- this guide
Power supply performance specifications Chapter 1- this guide
Programming
discrete fault inhibit (DFI) operation Chapter 4 - Programming Guide
from the analog port Chapter 4 - this guide
from the front panel Chapter 5 - this guide
over the GPIB Chapter 2 - Programming Guide
remote inhibit (RI) operation Chapter 4 - Programming Guide
status registers Chapter 4 - Programming Guide
Quick operating checkout (without load) Chapter 3 - this guide
Rack mounting Chapter 2 - this guide
SCPI programming language Chapter 3 - Programming Guide
Wiring
analog programming port Chapter 4 - this guide
discrete fault indicator (DFI) operation Appendix D - this guide
digital port Appendix D - this guide
GPIB controller Chapter 4 - this guide
load or loads Chapter 4 - this guide
local sensing Chapter 4 - this guide
remote inhibit (RI) operation Chapter 4 - this guide
remote sensing Chapter 4 - this guide
1
See the Table of Contents for complete list of topics.
To Next Page
Loading...
Need help?
General
