5
Notice
The information contained in this document is subject to change without notice. Agilent Technologies makes no
warranty of any kind with regard to this material, including but not limited to, the implied warranties of
merchantability, and fitness for a particular purpose.
Agilent Technologies shall not be liable for errors contained herein or for incidental or consequential damages in
connection with the furnishing, performance or use of this material.
This document contains proprietary information which is protected by copyright. All rights are reserved. No part of
this document may be photocopied, reproduced, or translated into another language without the prior written
consent of Agilent Technologies, Inc.
Copyright 1997, 2000 Agilent Technologies, Inc.
Printing History
The edition and current revision of this manual are indicated below. Reprints of this manual containing minor
corrections and updates may have the same printing date. Revised editions are identified by a new printing date. A
revised edition incorporates all new or corrected material since the previous printing date.
Changes to the manual occurring between revisions are covered by change sheets shipped with the manual. In some
cases, the manual change applies only to specific instruments. Instructions provided on the change sheet will
indicate if a particular change applies only to certain instruments.
Edition 1...............................................................June, 1997
Update 1...............................................................October, 2003
Instrument Identification
Agilent Technologies power supplies are identified by a 10-digit serial number. The format is described as follows:
first two letters indicate the country of manufacture. The next four digits are a code that identify either the date of
manufacture or of a significant design change. The last four digits are a sequential number assigned to each
instrument.
Item Description
US The first two letters indicates the country of manufacture, where US = USA; MY = Malaysia; SG = Singapore.
3631 This is a code that identifies either the date of manufacture or the date of a significant design change.
0101 The last four digits are a unique number assigned to each power supply.
Edition 2...............................................................September, 2000
To Next Page
Loading...
Need help?
General
