Agilent Technologies 8163A - Figure 1 Remote Control; Returning the Instrument to Local Control

Introduction to Programming GPIB Interface
18 Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Fifth Edition
Returning the Instrument to Local Control
If the instrument is in remote control, a screen resembling
Figure 1 will appear. Press [Local] if you wish to return the instrument to
local control.
Figure 1 Remote Control
If your Agilent 8163A/B, 8164A/B or 8166A/B is in local lockout mode
(refer to DISPlay:LOCKout on page 142) the Local softkey is not available.
NOTE