In this Manual
This manual contains information about SCPI commands which can be
used to program the following instruments:
• Agilent 8163A/B Lightwave Multimeter
• Agilent 8164A/B Lightwave Measurement System
• Agilent 8166A/B Lightwave Multichannel System
The Structure of this Manual
This manual is divided into 5 parts:
• “Introduction to Programming” on page 15 gives a general introduction
to SCPI programming with the Agilent 8163A/B Lightwave Multimeter,
the Agilent 8164A/B Lightwave Measurement System, and the
Agilent 8166A/B Lightwave Multichannel System.
• “Specific Commands” on page 43 lists all instrument specific
commands.
• “Instrument Setup and Status” on page 55, “Measurement Operations
& Settings” on page 79, and “Mass Storage, Display, and Print
Functions” on page 185 give fuller explanations of all instrument
specific commands.
• “VISA Programming Examples” on page 189 gives some example
programs showing how the SCPI commands can be used with the
Agilent 8163A/B Lightwave Multimeter, the Agilent 8164A/B
Lightwave Measurement System, and the Agilent 8166A/B Lightwave
Multichannel System.
• “The Agilent 816x VXIplug&play Instrument Driver” on page 213, “GPIB
Command Compatibility List” on page 245, and “Error Codes” on
page 257 give information about the Agilent 816x VXIplug&play
Instrument Driver, compatibility issues, and error codes.
Conventions used in this Manual
• All commands and typed text is written in Courier font, for example
INIT[:IMM].
To Next Page
Loading...
