Specific Commands Specific Command Summary
46 Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Fifth Edition
:CORRection:COLLection:ZERO? Queries the status of the last zero operation page 158
:PATH/? Sets or returns the regulated path. page 113
:POWer/? Sets or queries the output power value. page 152
:POWer:CONTRol/? Sets or queries power control mode status page 155
:POWer:OFFSet/? Sets or queries the power offset value. page 154
:POWer:OFFSet:POWermeter Calculates power offset from measured power values page 154
:POWer:REFerence/? Sets or queries the reference power value. page 153
:POWer:REFerence:POWermeter Copies power value from power meter to attenuator module ref.
power parameter
page 153
:POWer:UNit/? Sets or queries power unit used (dBm or W) page 155
[:STATe]/? Sets a source’s or attenuators output terminals to open or closed
or returns the current status of a source’s or attenuators output
terminals.
page 114
:READ[n][:CHANnel[m]]
[:SCALar]:POWer[:DC]? Reads the current power value from a sensor. page 89
:POWer[:DC]:ALL? Reads all available power meter channels. page 90
:POWer[:DC]:ALL:CONFig? Return all the slot and channel number of every available power
meter channel.
page 90
[:SCALar]:RETurnloss? Reads the current return loss value. page 91
[:SCALar]:MONitor? Returns the current power value from the monitor diode within a
return loss module.
page 91
:ROUTe[n]
[:CHANnel[m]]/? Sets or returns the channel route between two ports. page 169
[:CHANnel[m]]:CONFig? Reads the switch configuration of an instrument. page 170
[:CHANnel[m]]:CONFig:ROUTe? Reads the allowed switch routes of an instrument. page 170
Table 4 Specific Command Summary (continued)
Command Description Page
To Next Page
Loading...
Need help?
General
