ILT.107
**** ALL SELF-TESTS HAVE PASSED ! ****
No failures were found in any of the
tests on the self-test list.
....Options....
Abort Loop Log Cont
At the end of self-test, if the display shows
ALL
SELF-TESTS HAVE PASSED !
continue with ILT.108.
Otherwise, follow the directions displayed on the
synthesizer.
ILT.108
Were the self-tests run to conrm correct operation of
the synthesizer? For example, were self-tests run after a
repair, as a periodic check, or as part of a calibration?
Continue Done
Agilent 8360 Instrument Level Troubleshooting 1a-5
To Next Page
Loading...
