702 Chapter9
If You Have a Problem
Error Messages
ERR 585 RBW 300K Unable to adjust 300 kHz RES BW.
ERR 586 RBW 1M Unable to adjust 1 MHz RES BW.
ERR 587 RBW 30K Unable to adjust 30 kHz RES BW.
ERR 588 RBW 100K Unable to adjust 100 kHz RES BW.
ERR 589 RBW 300K Unable to adjust 300 kHz RES BW.
ERR 590 RBW 1M Unable to adjust 1 MHz RES BW.
ERR 591 LOG AMPL Unable to adjust amplitude in log scale.
ERR 592 LOG AMPL Unable to adjust amplitude in log scale.
ERR 593 LOG TUNE LIMIT Cal tune error from DC logger
calibration.
ERR 594 LOG OFST Attenuator calibration offset error from DC
logger calibration.
ERR 595 LOG ATTN Attenuator calibration absolute error from DC
logger calibration.
ERR 596 LOG FID Fidelity error from DC logger calibration.
ERR 597 LOG OFST Fidelity offset error from DC logger
calibration.
ERR 598 LOG OFST Fidelity offset unstable from DC logger
calibration.
ERR 599 LOG GAIN Fidelity gain error from DC logger calibration.
Error codes 600 through 699 relate to system failures.
Instrument service is required.
ERR 600 SYSTEM Hardware/firmware interaction; check other
errors.
ERR 601 SYSTEM Hardware/firmware interaction; check other
errors.
ERR 650 OUTOF RG ADC input is outside of the ADC range.
ERR 651 NO IRQ Microprocessor is not receiving interrupt from
ADC.
To Next Page
Loading...
Need help?
General
