EasyManuals Logo
Home>Agilent Technologies>Test Equipment>86100A

Agilent Technologies 86100A Release Notes

Agilent Technologies 86100A
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
22
N1010A FlexDCA and 86100A/B/C/D
Firmware Release Notes
General Defects Fixed
Fixed a defect with TDR calibrations (normalization) at long time ranges.
Known Issues
86119A (Optical Sampling Oscilloscope) is designed to work on software versions
A.03.06 and A.03.05 only.
A.10.03 Release Notes, April, 2011 (Differences from Release A.10.02)
General Comments
Various improvements made to support the N1010A FlexDCA application.
Requires Windows XP Service pack 2 or later. If you have an 86100C instrument
with Windows XP Service pack 1 installed on it, you must upgrade to Service Pack
2 before you can use firmware release A.10.03 or later.
Known Issues
86119A (Optical Sampling Oscilloscope) is designed to work on software versions
A.03.06 and A.03.05 only.
A.10.02 Release Notes, December, 2010 (Differences from Release
A.10.01)
New Feature List
Various improvements made to support the N1010A FlexDCA application.
General Defects Fixed
Fixed a defect that would cause a decrease in throughput when using the 86115D
module if one channel had the reference filter enabled while the other channel
was unfiltered.
Fixed a defect that would cause incorrect behavior of markers on S- Parameters
when using the 86100D mainframe.
Fixed a defect that would cause unpredictable frequency spacing when saving
Touchstone files on either the 86100C or 86100D mainframes.
Fixed a defect that would cause measurement errors in the vertical histogram if
the histogram window encompassed the entire display.
Various defects fixed to support the N1010A FlexDCA application.
Known Issues
86119A (Optical Sampling Oscilloscope) is designed to work on software versions
A.03.06 and A.03.05 only.
A.10.01 Release Notes, September, 2010 (Differences from Release
A.10.00)
New Feature List
Various improvements made to support the N1010A FlexDCA application. In the
clock recovery event register (see 86100A/B/C/D programmer’s guide), added
definition for bit 6 (FIN). The FIN bit indicates that a clock recovery relock

Table of Contents

Other manuals for Agilent Technologies 86100A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Agilent Technologies 86100A and is the answer not in the manual?

Agilent Technologies 86100A Specifications

General IconGeneral
BrandAgilent Technologies
Model86100A
CategoryTest Equipment
LanguageEnglish

Related product manuals