20
N1010A FlexDCA and 86100A/B/C/D
Firmware Release Notes
86100D/C Firmware Release Notes
A.10.80 Release Notes, June, 2012 (Differences from Release A.10.70)
New Features
• Support for the N2800A- series InfiniiMax III probes. New arguments added to the
:CHANnel:PROBe:SELect programming command as documented in the
programmer's guide.
General Defects Fixed
• Fixed a crash in the extinction ratio calibration on the electrical channel of the
86105C and 86105D modules.
Known Issues
• 86119A (Optical Sampling Oscilloscope) is designed to work on software versions
A.03.06 and A.03.05 only.
A.10.70 Release Notes, April, 2012 (Differences from Release A.10.60)
General Comments
• Requires Windows XP Service pack 2 or later.
• Added new Ethernet Mask: OTU4 G.959.1
New Features
• Support for 86108B Precision Waveform Analyzer module.
Known Issues
• 86119A (Optical Sampling Oscilloscope) is designed to work on software versions
A.03.06 and A.03.05 only.
A.10.60 Release Notes, December, 2011 (Differences from Release
A.10.50)
General Comments
• Supports connections from FlexDCA version A.1.60 and earlier.
• Requires Windows XP Service pack 2 or later.
New Features
• Added support for Option 500, Productivity Package, which includes Rapid Eye.
Rapid Eye significantly reduces the time required to acquire eye- diagram samples.
• Autoscale performance is significantly improved when Rapid Eye is enabled.
• Ability to calibrate the optical channel of 86105C, 86105D, and 86116C modules,
even if the electrical channel is damaged.
To Next Page
Loading...
Need help?
General
