9
N1010A FlexDCA and 86100A/B/C/D
Firmware Release Notes
• :SOURce:FILTer:CUToff (new)
• :SOURce:FILTer:STATe (new)
• :SOURce:FILTer:TYPe (new)
•:SOURce:FNAMe (new)
• :SOURce:FUNCtion (new)
• :SOURce:INVert (new)
• :SOURce:JITTer:RJ (new)
• :SOURce:JITTer:STATe (new)
• :SOURce:NOISe:RN (new)
• :SOURce:NOISe:STATe (new)
•:SOURce:OENable (new)
• :SOURce:OFFSet (new)
• :SOURce:PATTern (new)
•:SOURce:WTYPe (new)
:SPRocess Subsystem Programming Commands
• :SPRocess:DFEQualizer:BANDwidth (new)
• :SPRocess:DFEQualizer:BANDwidth:AUTo (new)
• :SPRocess:DFEQualizer:CLKDelay (new)
• :SPRocess:DFEQualizer:DWAVeform (new)
• :SPRocess:DFEQualizer:TAPS (new)
• :SPRocess:DFEQualizer:TAPS:AUTo (new)
• :SPRocess:DFEQualizer:TAPS:COUNt (new)
• :SPRocess:DFEQualizer:TAPS:RECalculate (new)
• :SPRocess:DFEQualizer:TARGet:AUTo (new)
• :SPRocess:DFEQualizer:TARGet:LOWer (new)
• :SPRocess:DFEQualizer:TARGet:UPPer (new)
:SYSTem Programming Commands Subsystem
• :SYSTem:FCONfig (new)
• :SYSTem:GTLocal (new)
• :SYSTem:LAUNch (new)
• :SYSTem:TEMPerature (new)
• :SYSTem:UAUToscale (deprecated)
• :SYSTem:UDEFault (deprecated)
A.01.80 Release Notes, June, 2012
(Differences from Release A.01.70)
General Comments
• FlexDCA requires Agilent IO Libraries 16.2 or later. If you have a prior version
installed, it will be upgraded to version 16.2.
• FlexDCA requires the Agilent licensing system 4.3 or later. This includes "Agilent
License Manager", "Agilent ACCL Licensing", and "Agilent Host Processor Platform".
• Removed the Control menu. The Auto Scale, Run, Stop, Single, and Clear functions
can more easily be accomplished by clicking the buttons that are shown to the
right of the menu bar. The Undo Auto Scale command has been moved to the top
of the Setup menu.
New Feature List
• Ability to use 86100D DCA- X applications. Added the Apps menu to the menu
bar for launching applications.
To Next Page
Loading...
Need help?
General
