42
N1010A FlexDCA and 86100A/B/C/D
Firmware Release Notes
• Autoscale hung when acquisition stopped before using autoscale
• Autoscale failure on math waveform turns on other waveforms
• :VIEW CGM does not work after BLANk if a measurement command is sent first
• :DISplay:DATa? returns inconsistent color scheme
• :DISK:LOAD returns error 46 if in Oscilloscope mode
• TDR fails vertical calibration if Threshold is set to "Units"
• RZ eye width algorithm seems to place L open too close to mean; modified
algorithm for unsymmetrical edges
• Module Delta Temperature reflects Mainframe temperature, not module
• Module calibration time comes from 2 different sources; problem during daylight
savings time change
• Measurement Limit Test still displays measurement after it's been turned off
• Histogram tab stops displaying histogram data after math function
• Delta Y now only shows value in Measurement Results tab when the units are the
same
• Databases dump when switching between RZ & NRZ measurements
• Cannot select CGM as source with :WAVEFORM:SOURCE+B34 command
• Cannot change channel offset for differential TDR channels
• :WAVEFORM:DATA? Returns incorrect values in ASCII mode
• :MEAS:CGRADE:JITTER? Does not return correct values; wasn't using source
specified in :MEAS:SOURCE
• :CHAN#:UNIT:ATT, :CHAN#:UNIT:OFF and :CHAN#:PROBE now blocked when
stimulus is on
A.02.20 Release Notes, August 2, 2001 (Differences from Release
A.02.10)
New Feature List
• Japanese Language Help
• Support for 86106B
• Support for 86109B
• Support for 86102U
Defects Fixed:
• Fixed defect that prevents the mask margins from being enabled when a setup
file containing margin information is loaded.
• Fixed defect that forced users to reload masks after performing an autoscale while
running mask test.
• The acquisition speed while eye measurements are turned on, which had been
previously degraded by a factor of four or five, is now fixed.
• GPIB disk store goes to setup directory instead of specified directory, this is now
fixed.
• Resolved a problem with the RZ remote query for contrast ratio which causes the
instrument to crash while in eye mode.
• The remote command mask load (MTES:LOAD) does not work in "C:\User
Files\Directory, this defect has been resolved.
• Modules insufficiently inserted produce an error message in the mainframe that
tell the user to reinsert with more force.
A.02.10 Release Notes, May 1, 2001 (Differences from Release
To Next Page
Loading...
Need help?
General
