27
N1010A FlexDCA and 86100A/B/C/D
Firmware Release Notes
timebase.
• Fixed a issue where bad data would get reported on clipped signals with precision
timebase.
• Fixed an issue where math signals were not auto scaling properly.
• If TDR calibration is valid and then a vertical cal later becomes invalid/
recommended, now a message will tell user TDR calibration is recommended.
• Fixed bug where :DISK:MDIRectory command would give error message upon
proper us of command.
• The minimum, maximum, and average impedance measurements can now? be
applied to math functions as well as channels and responses.
• Fixed issues with using Pattern Lock and precision timebase with a sub- rate
reference clock.
Known Issues
• 86119A (Optical Sampling Oscilloscope) is designed to work on software versions
A.03.06 and A.03.05 only.
To Next Page
Loading...
Need help?
General
