Chapter 1 1-183
Alphabetical Command Reference
PRES
PRES
Syntax
PRES;
Description
Front Panel Equivalents
NOTE Pressing the key on the analyzer will either invoke the factory preset
state, or a user-selected state (if one has been set up). Sending the PRES
command will always invoke the factory preset state. This is true even if the
analyzer is currently set up to recall a user preset state when the
key is pressed. For more information on user presets, see your analyzer’s
user’s guide.
NOTE This command should use OPC? to prevent timing errors with subsequent
commands. Example code written in BASIC:
10 OUTPUT 716;"OPC?;PRES;"
20 ENTER 716;X
Command Description Range Query Response
PRES Presets the analyzer to the factory preset
state. OPC-compatible. See also
Appendix A , “Preset Conditions.”
N/A N/A
Command Hardkey Softkey
PRES N/A
Preset
Preset
Preset
To Next Page
Loading...
Need help?
General
