Agilent Technologies 8753ES Reference Guide

6-14
Error Messages
Error Messages in Alphabetical Order
INSUFFICIENT MEMORY FOR PRINT/PLOT
Error Number
168
There is not enough memory available for the print or plot function. Increase the
available memory by changing or eliminating a memory-intensive operation
such as reducing the number of points in the sweep.
INSUFFICIENT MEMORY, PWR MTR CAL OFF
Error Number
154
There is not enough memory space for the power meter calibration array.
Increase the available memory by clearing one or more save/recall registers, or
by reducing the number of points.
INVALID KEY
Error Number
2
You pressed an undefined softkey.
ISOL AVERAGES < SWP AVERAGES
Error Number
223
The isolation averages are less than the instrument sweep averages. Increase
the isolation averages to be equal to or greater than instrument sweep averages.
This error can only occur when instrument averaging is turned on.
LIMIT TABLE EMPTY
Error Number
205
Limit lines cannot be turned on unless a limit table has been created. Refer to
the “Making Measurements” chapter of the user’s guide for information on how
to create a limit table.
LIST MODE OFF: INVALID WITH LO FREQ
Error Number
182
List mode has been turned off in the frequency offset mode because it is
incompatible with your selected LO frequency.
LIST TABLE EMPTY
Error Number
9
The frequency list is empty. To implement list frequency mode, add segments to
the list table.
LOG SWEEP REQUIRES 2 OCTAVE MINIMUM SPAN
Error Number
150
A logarithmic sweep is only valid if the stop frequency is greater than four times
the start frequency. For frequency spans of less than two octaves, the sweep type
automatically reverts to linear sweep.

Agilent Technologies 8753ES Specifications

General

Brand	Agilent Technologies
Model	8753ES
Category	Measuring Instruments
Language	English