EasyManuals Logo
Home>Agilent Technologies>Power Supply>E3641A

Agilent Technologies E3641A User Manual

Agilent Technologies E3641A
207 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #106 background imageLoading...
Page #106 background image
Chapter 4 Remote Interface Reference
An Introduction to the SCPI Language
105
4
Command Separators
A colon ( : ) is used to separate a command keyword from a lower-level keyword
as shown below:
ā€˜ā€˜
SOURce:CURRent:TRIGgered
’’
A semicolon ( ; ) is used to separate two commands within the same subsystem,
and can also minimize typing. For example, sending the following command
string:
ā€˜ā€˜
SOUR:VOLT MIN;CURR MAX
’’
... is the same as sending the following two commands:
ā€˜ā€˜
SOUR:VOLT MIN
’’
ā€˜ā€˜
SOUR:CURR MAX
’’
Use a colon and a semicolon to link commands from different subsystems. For
example, in the following command string, an error is generated if you do not
use the colon and semicolon:
ā€˜ā€˜
DISP:TEXT:CLE;:SOUR:CURR MIN
’’
Using the MIN and MAX Parameters
You can substitute
MINimum
or
MAXimum
in place of a parameter for many
commands. For example, consider the following command:
CURRent {<current>|MIN|MAX}
Instead of selecting a specific current, you can substitute
MINimum
to set the
current to its minimum value or
MAXimum
to set the current to its maximum
value.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Agilent Technologies E3641A and is the answer not in the manual?

Agilent Technologies E3641A Specifications

General IconGeneral
BrandAgilent Technologies
ModelE3641A
CategoryPower Supply
LanguageEnglish

Related product manuals