68 Chapter 5
Options and Accessories
Options
Option Descriptions
Each option is described below in alphabetical order.
12 Vdc Power Cable (Option A5D)
Option A5D provides a 12 Vdc power cable that allows your analyzer to be powered from 12 V
automotive or truck batteries.
3 Year Calibration Contract (Option W32)
Option W32 provides your analyzer with a 3 year analyzer calibration contract.
5 Year Calibration Contract (Option W52)
Option W52 provides your analyzer with a 5 year analyzer calibration contract.
5 Year Service Support (Option W50)
Option W50 provides your analyzer with a total of 5 years of service support. This adds a 2 year service
contract to the analyzer’s base 3 year warranty.
50 Ohm Tracking Generator (Option 1DN)
Option 1DN provides a 9 kHz to 1.5 GHz built-in tracking generator for the Agilent E7401A. Option
1DN provides a 9 kHz to 3 GHz built-in tracking generator for the Agilent E7402A, E7403A, E7404A,
and E7405A. This source creates a source-receiver combination that allows insertion-loss, frequency
response, and return-loss measurements. The tracking generator has a wide distortion-free dynamic
range, plus good sensitivity and selectivity.
STG Express Option: Standard Analyzer with Tracking
Generator
f
••
UK6
Commercial Calibration
f
•••••
UK9 Front Panel Cover •••••
UKB Low Frequency Extension ••••
W32 3 Year Calibration Contract •••••
W50 5 Year Service Support •••••
W52 5 Year Calibration Contract •••••
a. Included with new analyzer purchases.
b. This option requires Option A4H.
c. Option 1AX replaces the GPIB parallel with RS232 parallel. 1AX is not compatible with the Agilent E7415A EMI
Measurement Software.
d. Not compatible with option AYX.
e. Not compatible with option A4J.
f. This option is only available at time of purchase.
Option
E7401A
E7402A
E7403A
E7404A
E7405A
To Next Page
Loading...
Need help?
General
