1Getting Started
28 N1913/1914A Installation Guide
7 If you intend to program over LAN or use such programs, make sure
you have installed I/O software on your PC.
8 Use the Connection Expert utility of the IO Libraries Suite to add the
power meter and verify a connection.
9 You can use various programming environments to control the power
meter. For an overview about programming instruments via LAN, refer
to the connectivity guide.
Configuring the LAN Remotely
To automatically configure the LAN settings enable DHCP operation using
the SYSTem:COMMunicate:LAN:DHCP[:STATe] command.
To individually specify the settings use the
SYSTem:COMMuniucate:LAN:ADDRess, SYSTem:COMMunicate:LAN:SMASk,
SYSTem:COMMunicate:LAN:DGATeway,
SYSTem:COMMunicate:LAN:AIP[:STATe], and
SYSTem:COMMunicate:LAN:RESTart commands.
If you have installed other I/O software, refer to documentation that accompanies the
software.
To Next Page
Loading...
Need help?
General
