Agilent Technologies PSA Series Service Guide

362 Chapter 11
Assembly Replacement Procedures
A5 Power Supply
Replacement
1. Place the power supply assembly into position in the deck. Push
down to mate the assembly with the motherboard connector.
2. Refer to Figure 11-37. Using the T-10 driver, replace the 5 screws.
Torque to 9 inch pounds.
3. Replace the instrument top brace. Refer to the “Top Brace”
replacement procedure.

Agilent Technologies PSA Series Specifications

General

Brand	Agilent Technologies
Model	PSA Series
Category	Measuring Instruments
Language	English