Need help?Do you have a question about the Agilent Technologies PNA Series and is the answer not in the manual?
General| Number of Ports | 2 or 4, model dependent |
|---|---|
| Calibration | SOLT, TRL |
| Impedance | 50 Ohm |
| IF Bandwidth | 1 Hz |
| Power Requirements | 100 to 240 VAC, 50/60 Hz |
A list of safety points to consider when servicing your network analyzer.
A discussion of electrostatic discharge (ESD) and related recommendations and requirements for ESD protection.
Details on system specifications, instrument specifications, verification procedures, and performance tests.
The ANSI/NCSL Z540-1-1994 process of verifying your analyzer.
Procedure to verify system-level, error-corrected uncertainty limits for network analyzer measurements.
Verifies electrical performance of the analyzer using the N2721A software package.
Firmware-driven tests to fine-tune your analyzer for optimum response.
Important precautions against electrostatic discharge to prevent analyzer damage.
Guidance on how to begin the troubleshooting process based on failure symptoms.
Procedures to diagnose and resolve issues related to analyzer power-up.
Procedures to verify and troubleshoot the front panel assembly components.
Procedures to troubleshoot issues related to rear panel connectors and associated hardware.
Procedures to isolate faulty functional groups within the measurement portion of the analyzer.
A general description of the operating theory for the PNA series microwave network analyzer.
Theory of operation for the synthesized source group, including frequency range and output power.
Theory of operation for signal separation, including assemblies like the switch and couplers.
Theory of operation for the receiver group, covering mixers, modules, and motherboard.
Theory of operation for the frequency offset group, enabling different source and receiver tuning.
Theory of operation for digital control, covering front panel and data acquisition subgroups.
Theory of operation for the power supply assembly, detailing its DC output voltages.
The correct sequence for replacing an assembly in the network analyzer.
Warnings, cautions, and the assembly replacement sequence before starting repairs.
Detailed procedures for removing and replacing major assemblies in the analyzer.
Tests, verifications, and adjustments to perform after repairing an assembly.
Procedure for removing the outer and inner covers of the analyzer.
Procedure for raising, lowering, removing, and replacing the receiver deck.
Procedure for removing and replacing the front panel assembly.
Procedures for removing and replacing subassemblies within the front panel.
Procedures for removing and replacing the display inverter board and the display lamp.
Procedure for removing and replacing the A4 power supply assembly.
Step-by-step instructions to restore the operating system to factory condition.
Procedure to follow if the analyzer cannot boot from the hard disk drive.
Procedure to follow if the analyzer cannot boot from the floppy disk drive.
To Next Page
