Varian 310/320-MS LC/MS
Quadrupole Mass Spectrometer
Pre-installation Instructions
395411000: Rev. 5 1 of 14 Pre-installation Instructions
Checklist
NOTE: Do not unpack the shipping cartons.
Check off each checklist box after satisfying each requirement as described in the instructions. All requirements
must be met before requesting installation.
NOTE: If the site is not ready for installation when the Varian Representative arrives, Varian, Inc.
reserves the right to invoice for the Representative’s time.
REQUIREMENTS
;
Installation site is in compliance with all relevant safety regulations.
User Representative will be available during the installation and Varian certification period.
Entrance to the installation site is at least 92 cm (36 in.) wide.
Bench space is sufficient.
Bench can support system weight.
Bench does not vibrate.
Exhaust system is suitable.
Temperature maintained between 16 and 30 °C, (61-86 °F).
Relative humidity maintained between 20 and 80%.
Installation site is free of excessive particulate matter.
Specified electrical supply and power outlets are installed.
Nitrogen gas (at least 99% pure), regulator, and gas lines are installed.
Air (less than 0.1 ppm hydrocarbons), regulator, and gas lines are installed.
Argon (greater than 99.0% pure), regulator, and gas lines are installed. Argon required only for
triple quadrupole instruments.
Materials and solvents of specified grade are on site.
310-MS ONLY: Syringe pump similar to the Harvard syringe pump (Varian part number
2732070100).
Shipping cartons inspected for damage. If there was any damage, the damaged shipping carton
procedure was completed.
Requesting Installation
After preparing the site, contact the Customer Service office in your region to schedule installation.
To Next Page
Need help?
General
