Agilent Technologies XGS-600 - XGS-600 Accessories

XGS-600 Gauge Controller
16
DRAFT 4/
15/14
NOTE When installing and HFIG cable, make sure to connect the pig
tails from the ground cable to the ground stud. See item 7 in
Figure 1-2.
The Analog Board is identified by the Dsub connector pin
contacts versus the Convection Board socket contacts.
4. Turn on the unit using the rear panel power switch.
NOTE Gauges and accessories are available for the XGS-600
controller such as rack mount hardware, gauge and I/O
cables, and a tilt stand. See Table 2-1 and Table 2-2.
Table 2-1 XGS-600 Accessories
Cables Part Number
Cable Description 3 ft
. 10 ft. 25 ft. 50 ft. 65 ft 75 ft 90 ft 100 ft
UHV-24/UHV-24p PTFE UHV,
bakeable to 250° C
R32463010 R32463025 R32463050
UHV-24/UHV-24p Standard,
non-bakeable
R32453010 R32453025 R32453050
Glass BA Gauge Standard,
non-bakeable
R32443010 R32443025 R32443050
Ion Gauge Extension R32473065 R32473090
MBA-l00 Gauge R32483010 R32483025 R32483050
IMG-100 Gauge R03113010 R03113025 R03113050 R03113075 R03113100
IMG-UHV Gauge R03413010 R03413025 R03413065 R03413100
Thermocouple Gauge L91313010 L91313025 L91313050 L91313075 L91313100
ConvecTorr Gauge, Non-Bakeable L91223010 L91223025 L91223050 L91223100
XGS-600 I/O R32493010 R32493025 R32493050 Special Order
CT-100 with Analog Input Card R35883003 R35883010 R35883025 R35883050
FRG700/PVG/PCG with Analog Input
Card
R35893003 R35893010 R35893025 R35893050
CDG500, MKS with Analog Input
Card
R35903003 R35903010 R35903025 R35903050
FRG720/730 with Analog Input Card R35913003 R35913010 R35913025 R35913050