Agilent Technologies XGS-600 - Software Versions Screen

XGS-600 Gauge Controller
40
DRAFT 4/
15/14
Software Versions Screen
This screen shows the software versions on a board-by-board basis.
To open this screen select RESET SCREEN on the System Setup screen.
Figure 3-8 Software Versions Screen
SYSTEM RESET Use this to perform a full reset of user-defined variables, reverting
the system to as-shipped (factory-set) state.
EXIT Select to return to the Main Screen (page 25).
Large Font Screen
To open this screen select LARGER on the Main screen.
Figure 3-9 Large Font Screen
The leftmost column shows the User Label as configured on the Sensor Setup screen. You
can select which transducers appear on this screen by moving the cursor to the User Label
and using the +/- modify keys.
EXIT Select to return to the Main Screen (page 25).