XGS-600 Gauge Controller
DRAFT 4/15/14
25
Main Screen
Figure 3-2 shows the main screen, which appears at power up.
NOTE The sequence of gauge rows follows the board installation
sequence from left to right (when viewed from the front).
Use this screen to:
❑ View a list of installed sensors.
❑ View real-time pressure readings and status by sensor.
❑ Turn an ion gauge on/off or calibrate a Convection gauge.
❑ View the setpoint status.
Figure 3-2 Main Screen
Auto-On Indicator
Pressure ReadingsSensor ID’s
Soft keys
To Next Page
Loading...
