Agilent Technologies XGS-600 - Page 74

XGS-600 Gauge Controller
74
DRAFT 4/
15/14
NOTE All alpha characters must be upper case.
Notes to owners of Multi-Gauge and SenTorr:
❑ Most commands used by Multi-Gauge and SenTorr are still found in this protocol.
❑ Commands which apply to Multi-Gauge/SenTorr but do not apply to the XGS are
ignored by the XGS-600. There is no response and no error message.
❑ Any commands (ex. # 56-59) referring to a gauge or sensor type that is not supported
by the XGS-600 result in ?FF error message.
Backward-compatible sensor code can still be used in XGS-600 as with Multi-Gauge/
SenTorr protocol:
Read CNV gas type
(CNV only)
#aa4Ecn >x
where:
x=0 for Nitrogen/Air
x=1 for Argon
Set CNV gas type
(CNV only)
#aa4Fcnx
where:
x=0 for Nitrogen/Air
x=1 for Argon
>
Table B-1 Serial Command Set (Continued)
Description Command
Response from
XGS-600 Notes
Command
Entry Description Notes
c Sensor Code =T for TC/CNV
= I for ion gauge (HFIG or IMG)
Case sensitive.
n Sensor Count Counting TCs or ion gauges from left to right from the front
panel view.
Example: #0030I3 turns on the third ion gauge.