Agilent Technologies XGS-600 - Page 82

XGS-600 Gauge Controller
82
DRAFT 4/
15/14
Set Sensitivity
(4 bytes)
Byte 1- {55h}
Byte 2- {card info byte}
Byte 3- {mantissa digits 1,2}
Byte 4 - {mantissa digits 3,4}
Set TC/Conv to ATM
(2 bytes)
Byte 1- {A1h}
Byte 2 - {card info byte}
Set TC/Conv to VAC
(2 bytes)
Byte 1 - {A2h}
Byte 2 - {card info byte}
Read Pressure All
(1 byte)
Response
(3 bytes times the
number of gauges)
Byte 1 - {0Fh} Byte 1- {mantissa digits 1,2}
Byte 2- {mantissa digits 3,4}
Byte 3- {exponent} ..{ } { } { }
Runs from the lowest #
address gauge to the
highest# addr gauge
Table C-2 BCD Command List (Continued)
Command Byte # and Syntax Byte # - Response