8
Set Up and Installation
ROUND BALER
1. Locate a flat spot on the sidewall or tailgate as low as possible to the
bottom of the baler.
NOTE: Keep in mind when choosing a location for the sensors,
they must be place in an area on the sidewall or tailgate where
the hay is in bale form. Placing the sensors in an area where
the hay is still loose will result in inaccurate readings.
2. The sloped (leading) edge of the sensor should face the pickup as
shown in figure on page 7.
SEE DIAGRAMS ON PAGE 3 & 4
3. Tape the drilling template (D-8) onto the flat location and drill the
holes using the sizes indicated on the template. File any burrs from
the holes once the drilling is completed.
4. Now repeat steps 1 and 2 on the other side of the chamber.
Note: Your moisture tester uses 2 moisture sensor pads con-
nected to the chamber on the left and the right side.
5. Mount the sensor assemblies on the left and right side using the
hardware provided.
6. Place the sensor inside the chamber and place bolts (D-1) through
the sensor pad and through the chamber as shown in (Location A).
Attach washer (D-2) and nut (D-3) to bolt (D-1) but do not tighten.
7. Place bolts (D-1) through the sensor and through the chamber as
shown in (Location B). Place plastic insulator (D-5) then the plastic
washer (D-4) over bolt (D-1). Attach washer (D-2) and nut (D-3) to
the bolt (D-1) but do not tighten.
8. Now tighten the nuts and bolts at (Locations A and B).
9. Using one sensor cable per side, place one ring terminal per bolt
(D-1) at (Location B) and then attach washer (D-2) and nut (D-3) to
the bolts (D-1) and then tighten.
10. Most balers already have cable routes running from the baler to the
hitch area. If this is the case, follow this same route and use any
existing cable attachments. Route the sensor cable to the hitch
area of the baler so that is does not interfere with any moving parts.
Secure the cable with the supplied nylon ties (C-1).
To Next Page
Loading...
