agratronix BHT-2 - Default Chapter; Table of Contents

Set Up and Installation
Tester Components .................................................................................1
Install Moisture Sensors ..........................................................................3
Install Display Module ............................................................................11
Connect Sensor and Power Cables ......................................................11
Operation
Understanding Hay Conditions and Tester Readings .............................12
Button Functions ....................................................................................13
Operating the Tester ..............................................................................16
Change Tester Settings .........................................................................17
Troubleshooting
Troubleshooting the Tester ....................................................................20
Service
Replacing a Sensor Pad ........................................................................21
Care, Maintenance and Storage ...........................................................21
Accessories
Tester Accessories ................................................................................22
Warranty and Service ..........................................................................23
Contact Information ............................................................................25
DISCLAIMER- This baler hay moisture tester’s only intended use is for testing hay as
it is being formed into a bale inside the bale chamber. Do not attempt to use this tester
for any other purpose than testing of hay during baling. Using this product in a manner
other than what is described in this instruction manual will produce unknown results.
When comparing the results of the baler hay moisture tester and hay moisture probes
and windrow testers will often differ. These testers are testing the hay at different times
of hay bale production and when the hay is at different densities. Therefore, the baler
hay moisture tester’s accuracy should not be determined by comparison with a hay
probe type tester.
Contents
i