Service
REPLACING A SENSOR PAD
The sensor pads and contacts can become worn. Contact your Agra-
tronix tester dealer to order replacement sensor pads. See “INSTALL
MOISTURE SENSORS” for installation instructions.
CARE, MAINTENANCE AND STORAGE
After each use or after the harvest season, remove the display module (if
it is not inside a dry cab) and store in a clean and dry place.
Always use the weatherproof plug covers on the sensor cables to keep
moisture and dirt from getting into the electrical contacts.
The stainless steel contacts on the moisture sensors should be kept
clean for the best results. Clean with fine steel wool and/or mineral spirits
or alcohol. Dirty contacts can cause lower readings.
Check all nuts and screws on the moisture sensor plates and tighten if
necessary. Make sure the sensor pad leading edge is secured flat and
tight to the bale chamber wall.
21
To Next Page
Loading...
