©Copyright Agrispread September 2014 9
830 Belt Spreader
Removing Belt for Replacement
Should it be necessary to remove the belt, the following procedure should be adopted.
1. Slacken the both front adjuster’s worm drives right off.
2. Separate the bearing block carriers from the front adjuster’s on both sides of the
trailer.
3. Undo the grub screws on the inside of the front roller;
4. Remove bearing blocks on both sides.
5. Pull the bearing block with the loosened grub screws from the front roller shaft.
6. Slide Front Roller out from spreader
7. Remove all belt rollers by a tap up and out.
8. Loosen grub screws on rear belt roller
9. Loosen bolts which mount bearings to spreader
10. Remove bearings from rear roller
11. Slide the rear belt roller out from spreader
12. Remove the belt.
To install a new belt repeat the process in reverse order but ensure the belt is in correctly
Direction of rotation is marked and that the belt is on top side of pinch roller.
To Next Page
Loading...