©Copyright Agrispread September 2014 3
830 Belt Spreader
All maintenance work must be carried out when the machine is turned off and the key
removed.
Failure to comply with the instructions given in this manual may lead to the following
dangers:
- Danger of entrapment due moving conveyer type floor
-
- Danger of entanglement with spinners
- Danger of getting entangled in the shaft transmission parts if the guards are
removed;
Danger of falls when climbing ladder
Users should become thoroughly familiar with the contents of this manual before using,
servicing and mounting the spreader to the tractor. Never wear loose clothing when operating
the machinery. Always wear approved garments complying with accident prevention
provisions such as non-slip shoes, hearing and eye protection. Wear a jacket with reflecting
stickers if the spreader is used near public roads.
Work Area
The operator must remain seated while working the machine. Always ensure the tractor has
been turned off and the parking brake applied before any maintenance or changes are carried
out to the spreader.
Caution
The driven floor should never be operated with the doors in closed position this could cause
irreparable damage. On some fertilisers it should not be operated with less than 20 mm of gap
as packing will occur and the belt will jam. When spreading Steel Works Slag, always
operate the machine in the low gear with the door open as wide as possible.
To Next Page
Loading...