Agria 1000 - Operational and Tooling Problems

Power Hoe 1000 37
6. Troubleshooting
6
Problem Possible cause Possible solution Page
Engine does - Speed control linkages are Clean speed control 32
not run clogged or jammed linkages
smoothly
Engine - Speed and engine stop are not Readjust speed control
does not stop properly adjusted
¬ 33
when set
to stop
Engine - Air filter clogged Clean the air filter 29
output too low - Loose cylinder head or Tighten cylinder head,
¬
damaged gasket exchange gasket
- Poor compression Have engine checked ¬
Hoeing shaft - Speed control lever not Adjust speed control lever ¬ 32
does not come properly adjusted
to a stop in - Idling speed not properly adjusted Adjust idling speed
¬ 32
idling position
Tools slip - Too little clutch play Adjust clutch free play 27
(overload clutch)
¬ = For this purpose contact your agria workshop.