3) Using the Data Transmit Feature / RS232 & USB
There are two options for transmitting data from the E30FP-III while the USB cable is connected :
1) Manual-Transmit
After a product reading is taken, depress the [SEND DATA] key and the product score, with time and
date, will be transmitted. Only one data transmission will occur for each reading even if the [SEND
DATA] key is pressed again.
2) Auto-Transmit
a) Depress the [6] + [SEND DATA] keys at the same time to activate the auto data transmit feature.
A time and date will be transmitted with the notation that the auto data transmit feature is ON. With
auto-transmit ON, each time a reading is taken the product score with time and date will be
transmitted.
b) Depress the [6] + [SEND DATA] keys at the same time again to deactivate the auto data transmit
feature. A time and date will be transmitted with the notation that the auto data transmit feature is
OFF. No data will be transmitted unless the [SEND DATA] key is depressed.
Note:
• There is no handshaking capability between the E20CP-III and a connected PC or data acquisition
system. All standard analyzer functions operate independently and according to this Owner’s Manual
irrespective of the status and/or connectivity of the data transmit function
To Next Page
Loading...
Need help?
General