III. SETTING THE DATE / TIME
• Momentarily depress the [DATE/TIME] key on the function keypad
Current date and time settings will be displayed as follows:
MM:DD:YY= (Month:Day:Year) / HH:MM:SS = (Hours:Minutes:Seconds)
The bottom of the display will alternate between the following three statements:
[SKIP] KEY EXITS
- and -
[+/ -] SET DATE/TIME
- and -
[SCALE] PGM UNIT ID#
Note: To program an analyzer identification number, refer to page 8
If the date and time displayed are correct:
• Depress the [SKIP] key on the function keypad to save the settings and exit the Date & Time function
If you wish to change the Date & Time displayed:
• Depress the [+/-] key
The display will show: YEAR (YY):
• Using the numeric keypad, enter the last two digits of the year (i.e. 2018 would be 18)
The display will show: MONTH (MM):
• Enter the month in two-digit format (01 = January to 12 = December)
The display will show: DAY (DD):
• Enter the day of the month in two-digit format (01to 31)
The display will show: 24 HOUR (HH):
• Enter the current hour in 24hour format (i.e. 7 am would be 07, 10 am = 10, 12am / Noon = 12,
6 pm = 18, 12 pm / midnight = 24)
The display will show: MINUTE (mm):
• Enter the current time minutes in two-digit format (00 to 59)
Note: Seconds are not editable
The display will now show the new Date & Time settings
• Depress the [SKIP] key to accept the displayed Date & Time and exit the edit function
To Next Page
Loading...
Need help?
General