WARNING: Use only a 3-prong earth grounded connection. Do not bypass the power cord grounding pin
or serious electrical shock to the operator and damage to the unit may occur.
NOTE: The power switch for the E20CP-III is on the back panel next to the power-cord connector. Always
leave the unit on for best accuracy and stability; it uses very little power, about as much power as a 15-watt light
bulb.
● Turn the power switch to the -ON- position
The display should activate and begin timing a 45-minute warm-up period.
The unit model type, serial number and other information will appear on the display. The startup display
information will repeat until the 45-minute warm-up period is over.
At the end of the warm-up period, the display will show:
<<< COFFEE MODE >>>
Contact Agtron immediately if the Display does not show <<< COFFEE MODE >>> following the initial
warm-up period
Internal shipping damage may have occurred and a claim will need to be filed as soon as possible
To Next Page
Loading...
Need help?
General