14
4) RETENTION SYSTEM
Ci sono tre tipi di sistemi di ritenzione:
There are three types of retention system:
- DD
- Quick release buckle
- Micrometric adjustment buckle
The instructions for the use of all three types are given below.
4.1) DD retention system
To fasten the helmet, slot the
tape through the two rings
(1), pull the end of the tape
(2) until the strap presses
against the jaw and click the
anti-flapping press-stud (3)
into place as shown in the fig-
ure.
Check that the helmet fits
snugly (see the paragraph
entitled “Choosing the right
helmet” in the “Safety Warn-
ing” booklet).
1
2
3
To remove the helmet, re-
lease the press-stud by
pulling the end of the tape
and loosen the tape, pulling it
through the rings, using the
red tab as shown in the fig-
ure.
Own.Inst._GPTech:Own.Inst._GPTech 29-06-2007 15:18 Pagina 14
To Next Page
Loading...
Need help?
General
