13 THE RETENTION SYSTEM
13.1 CLOSURE
Warning! For a secure tightening
of the retention system, please
read the information on the Safety
Warning document.
Condition: the helmet is worn and reten-
tion system is loose.
• Insert the chin strap lace (1) into the
two D-rings (2).
• Insert again the chin strap through
the inner ring (3). So pull the final red
lace (4) until you feel the strap set-
ting against your mandible.
• Fold the chin strap and secure the
anti-waving automatic button (5).
→ Check if the helmet stays firmly se-
cured on the head.
13.2 OPENING
Condition: the helmet is worn and reten-
tion system is tied.
• Unfasten the anti-waving automatic
button (5).
→ Using the final red lace, loosen the
chin strap by removing it from the
rings.
14 LUBRICATING OIL FOR VISOR
MECHANISM
The supplied silicone oil application avoids the arise of corrosion and parasitic
creakings.
Condition: place the helmet on one of the two sides on a flat surface.
• Apply a moderate quantity of oil to the visor mechanism.
• Remove the oil excesses with a cloth.
Warning! In case of contact with the skin, wash with plenty of water and soap. In
case of contact with eyes, rinse with plenty of water and consult a doctor. In case of
ingestion consult a doctor. In case of inhalation, breathe in open air. Avoid exposure
to sunlight, keep it in a dry place and at a temperature under 50°C. Keep out of reach
of children.
Warning! Prevent the product from entering into the ground/subsoil. Prevent the
product from flowing into surface water and/or into the sewer system. Keep con-
taminated washing water and eliminate it. In case of penetration into watercourses,
soil or sewer system, inform the responsible authorities. Suitable material for col-
lection: absorbent, organic and sand material. Do not dispose of the container into
the environment.
1 2
5
34
5
V
16
To Next Page
Loading...
