11 THE CHIN STRAP COVER
11.1 REMOVAL
Notice! The lining removal is easier
if the cheek pads were previously
removed from the helmet.
Condition: place yourself in a sitting posi-
tion laying the helmet upside down on your
knees.
• Unfasten the red automatic button (1)
that connects the chin strap cover (2)
to the retention system (3).
• Extract the chin strap cover from the
retention system lace (arrow).
• Repeat the previous operations
on the other strip of the retention
system (4).
11.2 INSTALLATION
Condition: place yourself in a sitting position laying the helmet upside down on your
knees.
• Put the retention system lace (3) into the chin strap cover (2).
• Clamp the retention system lace to the chin strap through the specific red auto-
matic button (1).
• Repeat the previous operations on the other strip of the retention system (4).
12 THE AIR VENTS
12.1 FRONT VENTS
Condition: wear the helmet and make sure
of the three upper air vents location and
their drive.
• To open the lateral air vents (1), move
the sliders backwards. To close
them, move them forward.
• To open the central top vent (2), move
the slider upwards. To close it, move
it downwards.
12.2 CHIN VENTS
Condition: wear the helmet and make sure
of the two chin air vents location and their
drive.
• To open the chin air vents (1), move
the slider (2) downwards.
• To close the chin air vents, move the
sliders upwards.
13 24
1 12
2
11
15
EN
To Next Page
Loading...
