ahlmann AL 70e - Page 12

K65E/K75D/K95D/K95i 1-3 K65E/K75D/K95D/K95i 1-3
1.3.3 The personnel in charge of
working with the machine must read
the operating manual (machine and
engine) before start of work,
especially the chapter concerning
safety precautions.
This also applies to personnel
working occasionally with the
machine, e.g. during maintenance
work.
1.3.4 The driver must wear a seat
belt during operation.
1.3.5 Personnel working with the
machine must not wear long
flowing hair, loose clothing or
jewelry including rings as this could
cause injuries by getting caught up
or pulled in by the machine.
1.3.6 All safety and danger plates
on the machine must be observed.
1.3.7 All safety and danger plates
must be attached to the machine
and must be kept in legible
condition.
1.3.8 In case of modifications to
the machine, especially in case of
damages or changes in the
operating behavior of the machine
which could influence the safety of
the machine, stop the machine
immediately and inform the
competent person in charge about
the incident.
1.3.3 The personnel in charge of
working with the machine must read
the operating manual (machine and
engine) before start of work,
especially the chapter concerning
safety precautions.
This also applies to personnel
working occasionally with the
machine, e.g. during maintenance
work.
1.3.4 The driver must wear a seat
belt during operation.
1.3.5 Personnel working with the
machine must not wear long
flowing hair, loose clothing or
jewelry including rings as this could
cause injuries by getting caught up
or pulled in by the machine.
1.3.6 All safety and danger plates
on the machine must be observed.
1.3.7 All safety and danger plates
must be attached to the machine
and must be kept in legible
condition.
1.3.8 In case of modifications to
the machine, especially in case of
damages or changes in the
operating behavior of the machine
which could influence the safety of
the machine, stop the machine
immediately and inform the
competent person in charge about
the incident.