ahlmann AL 70e - Page 22

K65E/K75D/K95D/K95i 1-13 K65E/K75D/K95D/K95i 1-13
1.5.2.18 Before cleaning the
machine with water or steam jet
(high pressure cleaning unit) or
with detergent protect all areas
where water/ steam/ detergent may
penetrate and affect the functions
or safety of the machine by a
suitable cover or by applying tape.
In particular, such parts as engine
components, e.g. injection pump,
generator governor, starter are very
delicate.
1.5.2.19 After cleaning complete-
ly remove all protection covering
and tape.
1.5.2.20 After cleaning check all
pipelines for fuel, engine oil and
hydraulic oil for leakages, loose
connections, abrased parts and
damages. Eliminate defects imme-
diately.
1.5.2.21 Always fasten screw
connections after completion of
maintenance and repair work.
1.5.2.22 Should it be necessary to
dismantle safety devices during
mounting, maintenance or repair
work, these safety devices must be
re-installed and checked carefully
after completed maintenance and
repair work.
1.5.2.23 Make sure that fuel, ac-
cessory material and interchanged
parts are safely disposed of with no
danger to the environment.
1.5.2.24 The machine should be
checked by a specialist before
commissioning. In addition, it should
be checked after essential modifi-
cations before it returns to service.
1.5.2.18 Before cleaning the
machine with water or steam jet
(high pressure cleaning unit) or
with detergent protect all areas
where water/ steam/ detergent may
penetrate and affect the functions
or safety of the machine by a
suitable cover or by applying tape.
In particular, such parts as engine
components, e.g. injection pump,
generator governor, starter are very
delicate.
1.5.2.19 After cleaning complete-
ly remove all protection covering
and tape.
1.5.2.20 After cleaning check all
pipelines for fuel, engine oil and
hydraulic oil for leakages, loose
connections, abrased parts and
damages. Eliminate defects imme-
diately.
1.5.2.21 Always fasten screw
connections after completion of
maintenance and repair work.
1.5.2.22 Should it be necessary to
dismantle safety devices during
mounting, maintenance or repair
work, these safety devices must be
re-installed and checked carefully
after completed maintenance and
repair work.
1.5.2.23 Make sure that fuel, ac-
cessory material and interchanged
parts are safely disposed of with no
danger to the environment.
1.5.2.24 The machine should be
checked by a specialist before
commissioning. In addition, it should
be checked after essential modifi-
cations before it returns to service.