support@aibien.net
11
Part 4 – Camera Management
After the camera is powered on, wait for about 30 seconds, the camera rotates left and
right up and down to complete the self-check.
4.1 Add New Camera
Pay attention to the following points before add the camera in the app. (For new users)
1. Please use supplied power adapter, and make sure your router is working properly.
2. Please add a camera when the Wi-Fi signal is full.
3. About 30 seconds after powering on, the device starts to rotate left and right, up and
down to complete the self-check, and the device emits a tone to start binding.
4. We’ve provided a power extension cord in the package for installing the camera far
away from the power supply.
5. Please bind the device before installing it on the wall.
6. This camera only support 2.4GHZ Wi-Fi router, please make sure you are using a
2.4GHZ Wi-Fi router. Wi-Fi password does not support special characters.
7. This camera doesn’t support WEP safe mode, please switch the Wi-Fi WEP safe mode
to another mode.
8. Please follow the instructions and make sure the password is entered correctly.
9. If the camera failed to be added, please press the reset button for 5 seconds until you
hear deng~deng~deng~ prompt voice, then you can try again.
10. If the camera is always failed to be added after repeated attempts, please contact the
customer service.
11. One camera can only be added with one APP account, if the camera has been added
with another account already, then it can’t be added with any account again.
12. Please delete the camera in the APP firstly if you want to connect the camera to a
new APP account.
13. A camera can only be connected to one APP account. An APP account can connect
maximum 20 cameras.
Adding the device through the following steps
1
Please tap Add Device or Click this icon
button on the upper-lift corner of the
screen.
2
&
3
&
4
Connect the power and the camera is boosting, Please wait for 30
seconds, the camera will start to move around. Follow the prompts on the screen. Click
here
to confirm the camera status, click 'Next' to enter the next step.
To Next Page
Loading...