30
Note: In an interconnected system, the Alarm may also be triggered to sound by another Alarm. In
this case, the Alarm will sound but will not flash its red LED alarm indicator. This means that while
the Alarm is sounding, it is not the unit actually sensing the alarm event. If you have an Ei1529RC or
Ei450 Remote Control installed, press the locate switch to leave just the Alarm that has triggered the
system sounding and identify the source and type of the alarm.
• When fire is detected, you should evacuate the residence, closing all doors and windows along
the way.
• If CO is detected, you should open all windows and doors (if safe to do so), and then evacuate.
The Alarm memory is an important feature of the Alarm where even if the house is unoccupied during
an alarm condition it warns the homeowner that the Alarm has previously detected Fire or CO gas and
been in alarm. Table C outlines the indicators that are displayed in the memory mode.
Event type
x 2 every
48 secs
x 2 every
8 secs
x 4 every
8 secs
x 6 every
8 secs
x 8 every
8 secs
x 4 every
48 secs
x 6 every
48 secs
x 8 every
48 secs
FIRE
CO Gas Level
≥ 50ppm
Red LED
1
st
24h 1
st
24h> 24h on test button > 24h on test button
LED icon - Fire or CO (Ei3028 only)
Table C - Memory indicators
CO Gas Level
≥ 100ppm
CO Gas Level
≥ 300ppm
Flashing
Flashing
Flashing
Flashing
To Next Page
Loading...
