Aim-TTI TG5011A - Page 6

5
Output Filter
Selects between 50MHz Elliptic or 20MHz Bessel filter depending on the waveform.
Noise
Gaussian White Noise: Noise can be added to any carrier waveform (except pulse and square and
noise itself). The amount of noise added can be specified as 0% to 50% of the amplitude of the
carrier waveform. Noise can also be used as modulating waveform.
Bandwidth (-3dB):
20MHz typical
Noise crest factor (Vp/Vrms):
5.27
Output Level:
10mVp-p to 10Vpp into 50Ω
PRBS
Bit Rate
1µbps to 50Mbps, [1µbps to 25Mbps] 1µbps resolution
Sequence Length
2
m
-1, where m = 7, 9, 11, 15, 20, 23
Rise/Fall Times:
Rise and Fall times are varied simultaneously.
Range:
<8ns to 40µs [<13ns to 40
µ
s]
Internal Frequency Reference
Initial Setting Error:
<± 2ppm
Oscillator Ageing Rate:
<± 1ppm first year
Temperature Stability:
<1ppm over the specified temperature range
Modulation
AM
Carrier Waveforms:
Sine, Square, Ramp, Arb, PRBS
Modulation Source:
Internal/External
Internal Modulating
Waveforms:
Sine, Square, Up Ramp, Down Ramp, Triangle, Noise, DC, Sinc,
Exponential Rise, Logarithmic Rise and User Defined Arbs
PRBS-PN7, PN9, PN11, PN15, PN20, PN23
Internal Modulating
Frequency:
1µHz to 1MHz, 1µHz resolution
Amplitude Depth:
0.0% to 120.0%, 0.1% resolution
FM
Carrier Waveforms:
Sine, Square, Ramp, Arb, PRBS
Modulation Source:
Internal/External
Internal Modulating
Waveforms:
Sine, Square, Up Ramp, Down Ramp, Triangle, Noise, DC, Sinc,
Exponential Rise, Logarithmic Rise and User Defined Arbs
PRBS-PN7, PN9, PN11, PN15, PN20, PN23
Internal Modulating
Frequency:
1µHz to 1MHz, 1µHz resolution
Frequency Deviation:
DC to Fmax/2, 1µHz resolution