Technical Documentation - Datasheet MyChron 4 – Version 1.00
1
TECHNICAL DOCUMENTATION 13/02/2006 LOGGER
Notes: MyChron 4 technical documentation, dimensions and pinout Version 1.00
MyChron 4
Figure 1: Display MyChron 4
Introduction
MyChron 4 represents the new philosophy of AIM data acquisition
systems: a data logger with graphical display, easy to configure, easy to
read and, what make sit unique: expansible.
MyChron 4 has a graphical display that allows you to see the graphical
representation of your values, configurable RPM, Optical or Magnetic Lap,
1 Mb internal memory and capacity to record up to 1000 lap with up to 4
splits or 3 hours of sample at a 10Hz sampling frequency for channel, 1
temperature (water, exhaust gas or cylinder head, thermocouple or
Thermoresistor) and the automatic switch-off after 8 minutes of inactivity
(only external power versions).
Moreover MyChron 4 computes forecast lap time and shows times as
absolutes and as difference with the previous lap.
All these potentialities can grow with the optional E-box connected via
CAN to MyChron 4. Thanks to this expansion acquired channels will grow
in a very simple and quick way. the E-box, in fact, has two others
temperature channels and the speed channel (that together with MyChron
4 RPM allows you to compute and show engaged gear number).
The logger shows the following parameters:
• 1 temperature input (cooling water, cylinder head or exhaust gas,
thermocouple o Thermoresistor);
• RPM;
• Lap/Split Time;
• Logger or kart battery voltage;
The values stocked in 1Mb internal Memory can be downloaded both via
CAN on the 32 Mb Data Key memory (optional) and via USB and Data
To Next Page
Need help?
General
