AIPAS AIPAS-C1 - Warning Messages

Warning Messages Warning Messages
28 29
Frame
Never modify your frame or bicycle in any way as this could cause serious injury or death. Do not
sand, drill, file, or remove parts from your bicycle. Do not install incompatible components or
hardware.
Electrical Components
Always turn lights ON for your safety, especially when riding at night or in low visibility situations.
Range Estimates
The range the bicycle can go on a single battery charge can vary significantly between riders,
terrain, wind conditions, user input, and additional cargo weight. The following table shows
estimates of potential ranges riders may expect in different conditions.
Set the display brightness such that you can adequately see important information like speed or
warning symbols. Display brightness that is incorrectly set can result in dangerous situations.
Do not allow yourself to be distracted by the display. If you do not concentrate on the trac
around you, you risk being involved in a crash. If you want to change any settings other than the
PAS level, always stop before changing the settings or display.
Motor & Electric System
Do not open the drive unit yourself. The drive unit must only be repaired by qualified personnel
using only original parts. This will ensure that the safety of the drive unit is maintained.
Brake System
ALWAYS apply the right brake lever (rear wheel) before and during the use of the front brake.AL-
WAYS apply even pressure to both brake levers when blowing down or stopping. If only the front
brake is applied while slowing or stopping quickly, you may be ejected over the front handlebars.
Before riding, check to ensure brake levers do not touch the handlebars when fully applied, If
either lever touches the handlebars screw or unscrew the barrel adjuster to increase tension in
the brake cable. If this does not fix the problem, take your bicycle to an experienced bicycle
mechanic for further adjustment.
Disc brake rotors will become hot during use and will stay hot for a short period after use. To
prevent burns, do not touch the disc rotor right after use.
Unauthorized opening of the drive unit will render warranty claims null and void.
Under extreme conditions, such as continuously high loads at low speeds when riding up hills or
carrying loads, parts of the motor can reach high temperatures.
All components fitted to the drive unit and all other components of your Aipas eBike PAS system
(e.g. chaining, chaining receptacle, pedals) must only be replaced with identical components or
components that have been specifically approved by Aipas eBikes. This should help protect the
motor from overloading.
Always remove the battery pack from your Aipas eBike before beginning work (e.g. inspection,
repair, assembly, maintenance, work on the chain, etc.), transporting it with a car or on an
airplane, or storing it. Battery pack removal should prevent unintentional activation of your Aipas
eBike.
Do not make any modifications to your Aipas eBike or attach any other products that might
increase the performance of your Aipas eBike. Doing so will generally reduce the service life of
the system and risks damaging the drive unit and the bicycle. You also run the risk of losing the
guarantee and warranty claims on the bicycle you have purchased.
All tests were performed with:
Flat ground
Few bumps
Little to no wind
Top speed set to 20 mph
Few starts and stops
No additional cargo
Temperature ~75°F
Rider weight ~180 lbs
CST BFT tires at ~30 PSI