MaintenanceMaintenance
40 41
You should have your bicycle maintained at regular service intervals at your local bicycle shop.
Check drivetrain for proper alignment
and function (including the chain,
freewheel, chainring,and derailleur).
Clean frame by wiping frame
own with damp cloth.
Replace any components
confirmed by Aipas
Product Support or a
certified,reputable bike
mechanic to be damaged
beyond repair or broken.
Use barrel adjuster(s) to
tension derailleur/brake cables
if needed.
Standard tune-up by
certified,reputable bike
mechanic is recommended.
Replace brake pads.
Replace tires if necessary.
Replace cables and
housings if necessary.
Replace brake and shift
cables if necessary.
Clean and lubricate drivetrain.
Clean brake and shift cables.
Balance the battery.
Check crankset and pedal
torque.
True and tension wheels if any
loose spokes are discovered.
Replace brake pads if
necessary.
Grease bottom bracket.
Check wheel trueness and for quiet
wheel operation (without spoke noise).
Check condition of frame for any
damage.
Inspect drivetrain (chain, chainring,
freewheel, and derailleur).
Check brake pad alignment, brake
cable tension.
Check bike is shifting properly, proper
derailleur cable tension.
Check brake and shifter cables for
corrosion or fraying.
Check accessory mounting (rack
mounting bolts, fender hardware, and
alignment).
Check chain stretch.
Check spoke tension.
Inspect all cables and housings.
NEVER open any of the components, including the battery, display, motor, or PAS sensor. Service
should only be performed by a bicycle repair shop.
Always remove the battery pack before performing any bicycle inspection, maintenance, or
repair.
If you suspect that something is loose, do not ride your bicycle. All nuts, bolts, and screws require
the proper tightening force. Too little force and the fastener may not hold securely. Too much
force and the fastener can strip threads, stretch, deform, or break. Either way, incorrect tighten-
ing force can result in component failure, which can cause you to lose control and crash. Take
your bicycle to a bicycle repair shop for service.
Do not paint any components of your Aipas eBike as they may cause premature failure of the
component.
Do not submerge your Aipas eBike or its components in water use a pressure washer to clean it.
Always observe the operating and storage temperatures of your Aipas eBike and its components.
Protect motor, display, and battery pack against extreme temperatures (e.g. from intense
sunlight without adequate ventilation). Extreme temperatures can damage components (espe-
cially the battery pack). Please have your Aipas eBike serviced at least once a year.
Note: Our warranty does not include any maintenance fees
Monthly,
250-750 mi
(402-1207km)
Months,
750-1250mi
(1207-2011km)
Inte al
Inspect
Se
ice Replace
Weekly,
100-200 mi
(160-321km)
To Next Page
Loading...