Thinks To Know Before The Ride Battery Safety
32 33
How To Start And End Your Ride
Battery pack refers to all original Aipas eBikes battery packs.
The safety of both our customers and our products is important to us. Our eBike batteries are
lithium-ion batteries, developed and manufactured with the latest technology. We comply with
or exceed the requirements of all relevant safety standards. When charged, these lithium-ion
batteries contain a high level of energy. If a fault occurs (which may not be detectable from the
outside), in very rare cases and under unfavorable conditions, lithium-ion batteries can catch fire.
Take care when using and charging your battery. Failure to follow the guidelines below could
damage property and/or serious injury. Contact Aipas eBikes immediately if you have any
questions regarding battery safety.
Your Aipas eBike battery must not be opened, even for repairs. There is a risk your eBike battery
could catch fire, e.g. due to a short circuit. This risk increases if an eBike battery that has already
been opened is reused at a later point in time. Do not attempt to repair an eBike battery in the
event of a fault. Have it replaced with an original Aipas eBike battery pack.
The battery is protected against deep discharge, overloading, overheating, and short-circuiting
by Electronic Cell Protection (ECP). In the event of a fault, a protective circuit switches the
battery pack off automatically.
Only use original Aipas eBike batteries for your eBike. Using other batteries can lead to injuries
and pose a fire hazard. Aipas eBikes accepts no liability or warranty claims if other batteries are
used.
Note:Exercise extreme caution when using the twist throttle. When at a complete stop with
the bicycle power ON, be careful not to twist the throttle, or the bicycle could accelerate and
cause you to crash.
Do not engage in Walking Mode when riding or sitting on your Aipas eBike. Holding the minus
(-) button will engage the motor up to a walking speed.
To prevent serious injury or death:
Do not leave your battery unattended while charging.
When removing the battery, unplug the rubber stopper on the charging point.
Please remove the battery from the bicycle when not in use and store in a secure location to
prevent unauthorized use.
Please do not submerge the battery in liquid of any kind.
Do not touch the terminals on your battery.
Turn the display OFF when not in use and before removing the battery pack.
Battery leakage may occur under extreme usage or temperature conditions. Avoid contact
with skin and eyes. Battery liquid is caustic and could cause chemical burns. If battery liquid
comes in contact with the skin, wash quickly with soap and water. If the liquid contacts your
eyes, immediately flush eyes with water for a minimum of 15 minutes and seek medical atten-
tion. The battery pack should not be excessively dicult to insert or remove. Do not force the
battery pack in or out of the bike frame.
Insert key and turn counterclockwise to the ON position. The key will be parallel with the
frame and you will not be able to remove the key from the battery pack.
1.
Hold down the button located on the left handlebar until the display comes on.2.
Select a Pedal Assist (PAS) level using the plus (+) and minus (-) buttons. PAS 0 provides no
motor assist. PAS 1 is the lowest level of assist and PAS 5 is the highest level of assist.
3.
When the bicycle is at a complete stop, press and hold the button to turn the display OFF. This
ensures the motor will not activate until the display is turned ON again and you are ready to
ride.
4.
To Next Page
Loading...