Legal Warranty
44 45
Liability Disclaimer
Riding any kind of bicycle comes with inherent risks and dangers that cannot be predicted or
avoided. These dangers could result in a serious accident, injury, or death of the rider. It is the sole
responsibility of the rider to become properly educated and prepared to ride safely. Once in
possession of the bike, Aipas eBikes strongly encourages and recommends that all customers
have a certified and reputable bicycle mechanic complete a full inspection of each component
on the bicycle to ensure it is safe for operation. Aipas eBikes makes no claims or guarantees that
the brakes, battery, frame, motor, motor controller, display, electrical cables, electrical cable
housings, fasteners, grips, fork, stem, shifters, headset, seat post, seat post clamp, handlebar stem
clamp, saddle, wheel hubs, handlebars, spokes, rims, tires, tubes, derailleur, freewheel, cassette,
throttle, kickstand, lights, reflectors, hardware, bottom bracket, or any other part or accessory,
will be properly secured and adjusted upon arrival. Before every ride, fully inspect your bicycle to
ensure everything is secured and adjusted properly.
FCC
This equipment has been tested and found to comply with the limits of a Class B digital device,
under part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. lf this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the follow-
ing measures:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
This device may not cause harmful interference
This device must accept any interference received, includinginterference that may cause
undesired operation.
Please note that changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver
Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with radio frequency exposure limits set forth by the FCC for an
uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 5 mm between
the device and the user or bystanders.
This device must not be co-located or operating in conjunction with any other antenna or
transmitter.
To Previous Page
Loading...