AIPAS AIPAS-C1 - Setting up Your Aipas Ebike

Setting Up Your Aipas eBikeSetting Up Your Aipas eBike
10 11
1
Locate the quick-release lever. Open the
lever and remove the thumb nut, safety
hook, cone spring (opposite the lever).
Keeping the washer and other safety
hook and cone spring in place on the
lever side.
3
Tighten the nut onto the fork with No.15
wrench.
2
Line up the fork with the axle at the
center of the wheel. Make sure there's a
spacer between the fork and wheel on
each side. Install safety hook, gasket, and
nut in turn.
4
Install the front fork cover.
Front Fork
1
Take out the fender, remove the nut,
washer and bolt at the top of the front
fork.
2
Take out the headlights and screws
(including1xBolt,1xWasher, and 1xNut)
Slide the fender through the fork.
Reattach the bolt, washers.fender, head-
light, and nut (in that order) with 8mm
wrench.
3
Remove the nut, washer, and bolt at the
bottom of the front fork slide the fender
through the fork. Reattach the lower
fender screws.
4
Plug in the headlight. Locate the two
sides of the orange, three-pin headlight
connector, carefully align the internal
pins and notches and external arrows,
then press directly together without
twisting to fully seat the connection.
Front Fender & Headlight
NOTE: This manual is not intended to be an extensive reference book about service, mainte-
nance, and/or repairs.You can find more information on our website: Aipasbike.com
Note:
When properly installed, the front wheel should be fully seated and centered in the
dropouts of the front fork, The brake rotor should be in between the brake pads in the
brake caliper, and the front fork nut should be fully and properly secured. Ensure the front
wheel is properly secured before moving on to the next step.